So, back to the yew and the bending of the remains of the original trunk. In summary, I have tested two methods of bending thick branches_dead wood. 1. Method cut and close 2. Hot water to soften the wood to make it less resistant to bending (see the previous article for details ) After the bending and bit of carving Top jin_before the bending After. Detail As a hobby joiner I have always thought about bending thick branches using heat as this is very old technique used in joinery for centuries. Well, I should rather say using hot steam than just heat. In practice, I have simplified the thing even further and instead of using the hot steam I have used a boiling water. After this treatment I felt that the wood is "softer" and I was able to bend it. Definitely much less than I have hoped, though. I think that the hot steam would work much better nevertheless I would need quite different set up for this. Taking into acc
The first few days of the new year are a bit lazy. So why not to take the advantage of it and share some other trees? The mahaleb Zorro is one of my largest trees. Well, better to say heaviest ones. It is not very large, in fact it is just about 50 cm in height and about 70 cm in width. But the trunk is quite massive and the pot needs to be quite large to accomodate the long surface root. The shape is not very typical for deciduous tree but I do like it that way. And that counts... Still long way to go... The "new part" clashes with the old one - just looking like a baby's arse. Not to mention a better taper and finer ramification... Hope to find some time later on to repot it and while there to change the planting angle. The left side is right now planted too deep. Height: 50 cm Width: 70 cm Pot: China
Super Vlado. Nech ti to túto sezónu dobre rastie.
ReplyDeleteDíky, Maroš. Tobě to taky kvete, radost se podívat.
ReplyDelete